The Create Panels command has been modified so that it can be used to create panel sets along multiple AutoChart Route entities in a single operation. This means that Create Panels can now be run in Single Route mode (as per the previous Create Panels command) where the user selects a single polyline to create panels against, or in Multiple Routes mode where a number of AutoChart Route entities can be selected and panels will be created against all of the routes with the Panel ID automatically derived from the Route ID.

The basic dialog settings remain the same whether Create Panels is used in Single Route or Multiple Routes mode except that the Route Identifier field is grayed out in the Multiple Routes mode (as the Route Identifier is automatically set from the Route ID of each AutoChart route). In Multiple Routes mode the polylines selected must be AutoChart Route entities - i.e. they must have either been imported using the AutoChart Import Route command or have had an AutoChart Route ID assigned to them using the Attach Route Info or Attach Route Info by Layer commands. In Single Route mode, any line or polyline can be selected.