|
|
|
FR715 - Label Route Points |
|
|
|
|
|
||
|
FR715 - Label Route Points |
|
|
|
|
|
|
FR715 - Label Route Points
|
|
|
FR715 - Label Route Points |
|
|
|
|
|
||
|
FR715 - Label Route Points |
|
|
|
|
|
|
An option has been added to the Label Route Points command to use the Curve data of a Design Route to label the Route bends. The option requires that the Route Call-out symbol contains 20 attributes in the order:
| • | Curve Number |
| • | Tangent Point 1 ID |
| • | Tangent Point 1 Kp |
| • | Tangent Point 1 Easting |
| • | Tangent Point 1 Northing |
| • | Tangent Point 1 Latitude |
| • | Tangent Point 1 Longitude |
| • | Tangent Point 2 ID |
| • | Tangent Point 2 Kp |
| • | Tangent Point 2 Easting |
| • | Tangent Point 2 Northing |
| • | Tangent Point 2 Latitude |
| • | Tangent Point 2 Longitude |
| • | Intersection Point ID |
| • | Intersection Point Easting |
| • | Intersection Point Northing |
| • | Curve Radius |
| • | Curve Tangent |
| • | Curve Delta Angle |
| • | Curve Length |
The relevant Information will be extracted from the curve tangent points and the remaining attribute values calculated from the properties of the curve.
To use the option simple tick the Curve Data checkbox in the Label Route Points Dialog. The Kp, Grid Coordinate and Geographic Coordinate output are enabled by default and the output format for these values should be set as required.
This produces an output as per the example below:
